(1) Stone Crusher at work , because the device is a high-speed equipment , should pay special attention to production safety . Relevant personnel should stay away from the equipment, machine repair For after the shutdown .

(2) Triangular drive belt tensioning size should be adjusted as appropriate to ensure that the triangular tape should be grouped matching, then each group length as much as possible . Should be adjusted will be the difference of the two motor current does not exceed 15A .

(3) Stone Crusher  Mobil car super grease or # 3 Lithium Grease , 400 hours of each work by adding the right amount of grease to work 2000 hours to open the bearing spindle assembly cleaning , general work 7200 hours and replaced with new bearings .

(4) Downtime on a regular basis to open within the observation door observation crusher wear , the center feed tube , cone hat , on the impeller , obscene Road liner, circular shield, wear block wear , wear shall promptly replace or repair, replacement of wear block should be replaced at the same time to ensure that the wear blocks weigh the same . Observe the door, to observe the inner workings of the crusher can process open , to avoid danger. Found that the impeller body wear timely replacement patches to find the manufacturer .
Thank you for your interest in YiFan. Please use any of the methods below to get in touch with us.
Add: The Middle of Zhengyuan Road, Xingyang Eastern Development Zone.
zip:450100
E-mail：yifanseo@yfmac.com
MSN On line: yifancrusher@yahoo.cn
ICQ: 639607958 QQ: 2502761202
Tel: +86-371-64628852 Fax: +86-371-64628872
The article by Crushing Equipment,Stone Crusher Yifan Machinery Editor: http://www.stonecrusher.org/, please indicate the source , little effort , thank you .

Message Online

• Fifth-generation sand making structural characteristics and its applicati
• The stone crusher is widely used in the garbage ceramic sand production line

• Stone Crusher
• Cone Crusher
• Mobile Crusher
• Sand Maker